A frayed or snapped lift cable throws the whole door off balance, and a door hanging crooked on one cable is a genuine safety hazard. We replace cables and inspect the drums they wind onto.
When one lift cable fails, the other has seen the same wear cycle. We replace both to prevent a repeat call.
Frayed cables often trace back to worn or damaged drum grooves, so we inspect the drums every time, not just the cable.
Lift cables connect directly to spring-loaded drums, so replacement requires the same careful tension handling as spring work.
We carry the common cable lengths and gauges for most residential door sizes.
Whatever brought you here, one of these service lines is the fix, and one call gets a technician moving.
A snapped cable leaves the door hanging unevenly on the remaining side, an unsafe condition we treat as priority.
Fraying cable strands are a warning sign of imminent failure. We replace before it snaps and drops the door unexpectedly.
A cable that's jumped its drum groove can jam the door mid-cycle. We reset it correctly and check for the underlying cause.
We match new drums to the correct diameter for your door's cable length requirements.
Correcting an uneven lean means addressing the cable, checking the spring pair, and confirming the track is still square.
Tell us if the door is hanging crooked or jammed, that detail helps us prioritize the call correctly.
Cable stock on the truck means most calls avoid a second trip for parts.
We check both cables and the drums together, then quote a flat price covering the full fix.
Cables replaced, tension balanced, and the door tested level before we leave, backed by written warranty.
“Door was hanging at an angle after a cable snapped. They replaced both cables and it's perfectly level now.”
“Explained why replacing just one cable wasn't a real fix. Makes sense once you see the wear pattern.”
“Door was jamming mid-cycle for weeks. Cable and drum issue, fixed in one visit.”
One side losing tension while the other holds is the classic sign of a single cable or spring failure.
Both cables typically get replaced together to avoid a near-term repeat call.
We treat cable failures as priority calls given the safety risk involved.
Repeated slipping points to a drum issue rather than just the cable itself, which we'll inspect.
You'll get a confirmed price on-site once the technician inspects the full cable and drum setup.
A snapped-cable call usually resolves in under two hours on-site.
Licensed technicians, flat-rate pricing, and a truck stocked for this exact job.
☎ Call +1-831-293-1591From one side of Kenyon to the other, dispatch is built to reach you quickly.
Embedded Map Placeholder for Kenyon, MN